![]() BLADE INDUCTRIX FPV HOW TOIf you're wondering how to identify CW and CCW props just look at the curvature of the blades. This is opposite what most of us are used to. Clockwise (CW) props go on the red and blue motors and counter-clockwise (CCW) go on the black and white motors. Twist each pair of motor wires to shorten them and plug them in.I found it helpful to put pressure against the bottom of the plastic motor case while avoiding any stress to the struts. Push the motor wires through the plastic casing and gently slide each motor in.With your quad upright the red and blue wired motors belong on the front right and the rear left while the black and white wired motors go to the front left and rear right. BLADE INDUCTRIX FPV INSTALLOnce you've removed the motors you can install your upgraded motors:.Hold the bottom of the plastic motor case and slowly twist the motor out. Grab a pair of pliers and carefully twist the top of the motor (not the shaft, but the whole motor) until it starts to move.You should now be able to pull the props off with your fingers. ![]() If your tool increases in width from the tip you can push your tool through this space sliding the motor out further.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |